Setting Up The Internal-Mount Model; Before Installing - Nikon 35mm User Manual

5. Setting Up the Internal-mount
Model
The internal-mount scanner is easy to install, following the
procedure described below.

5.1 Before Installing

The internal-mount scanner is shown below. Note that the
front of the internal-mount model is identical to that of the
standard model.
Front panel
The front of the scanner includes the film slot and the status
display LED.
Status display LED Film Slot
Rear panel
The rear panel of the internal-mount scanner is shown below.
The rear panel contains the DC power connector, SCSI
connector, and configuration DIP switch block.
Configuration
DIP switch
The default DIP switch configuration is shown in Table 5.1. The
meaning of the SCSI ID DIP switch is explained later. The
internal-mount scanner is set at the factory to SCSI ID #5.
DIP Switch
1
2
3
4
Table 5.1 Factory set default DIP switch configuration
- 27 -
SCSI Power
Connector Connector
Default Usage
Closed SCSI ID bit 0 = 1
Open SCSI ID bit 1 = 0
Closed SCSI ID bit 2 = 1
– (Not used)