Entering The Gamma Editor; Loading The Factory Default Gamma Curves; Loading Custom Gamma Curves (Macintosh Only) - Nikon Scanners Software Reference Manual

The Gamma Curve Editor Dialog
Clicking the G
Editor dialog.

Loading the Factory Default Gamma Curves

If you have sent custom gamma curves to the scanner during a scanning session,
the active gamma curves were overwritten. To reload the default gamma curves back
into the Gamma Curve Editor dialog, simply click the S
If the Option key (Macintosh) or Control key (Windows) is held down while the
S G
CANNER AMMA
16.7b for Windows, all three (R,G,B) curves will be read from the scanner. Similarly, if
the Master curve is active when the S
will be read from the scanner.
Figure 16.7a Reading gamma curves from the scanner, key command – Macintosh.
Figure 16.7b Reading gamma curves from the scanner, key command – Windows.

Loading Custom Gamma Curves (Macintosh only)

Custom gamma curves created in your imaging application can be loaded by
clicking on the L
dialog will be presented prompting you for the location and name of the desired gamma
file, as shown in Figure 16.8.
Page 142
E button in the Scan dialog opens the Gamma Curve
AMMA DITOR
button is clicked, as shown in Figure 16.7a for Macintosh and Figure
CANNER
button in the Gamma Curve Editor dialog. Once clicked, a file
OAD
G
CANNER AMMA
G button is clicked, all of the curves
AMMA
Software Reference for Scanners
Chapter 16
button.