Chapter 10: Digital Keypad - Honeywell VFD CORE Installation Instructions Manual

CHAPTER 10: DIGITAL KEYPAD

HCRDKEYPAD
CORE
F1 F2
COMM
ERR
ESC
ENTER
HAND
FWD FWD
RUN
REV
Key
This is the RUN/START command to the VFD when in Hand/Keypad control only.
RUN It can operate the AC motor drive by the function setting and the RUN LED will be ON.
Stop Command Key. This key has the highest processing priority in any situation. Drive will always STOP
when this button is pressed.
STOP
The RESET key can be used to reset the drive after the fault occurs. For those faults that can't be reset by
RESET
the RESET key, see the fault records after pressing MENU key for details.
This key controls the operational direction of the motor. NOT activated out of the box.
FWD
REV
Press ENTER and go to the next submenu. If at the parameter level, press enter to modify and press
enter to save changes
ENTER
ESC key function is to leave current menu and return to the last menu. It is also functioned as a return key
in the sub-menu.
ESC
Press menu to return to main menu. See main menu descriptions on following pages.
MENU
Communication Interface
RJ-45 (socket)、RS-485 interface;
Installation Method
Embedded type and can be put flat on the surface of the control box. The
front cover is water proof.
Charge the digital keypad for 6 minutes before you use it to program the VFD.
F3 F4
RUN
MENU
AUTO
STOP
RESET
M31501
Table 1. Descriptions of Keypad Functions
Descriptions
91 63-4528—04