Honeywell VFD CORE Installation Instructions Manual page 157

Output when Frequency ≤ Pr.02-
30
32
31 Y-connection for the Motor Coil
32 D-connection for the Motor Coil Active when PR.05-24 is higher than Pr.05-23 and time is more than Pr.05-25.
Zero Speed (actual output
33
frequency)
Zero Speed with Stop (actual
34
output frequency)
Error Output Selection 1 (Pr.06-
35
22)
Error Output Selection 2 (Pr.06-
36
23)
Error Output Selection 3 (Pr.06-
37
24)
Error Output Selection 4 (Pr.06-
38
25)
Speed Attained (including zero
40
speed)
44 Low Current Output
UVW Magnetic Contactor
45
enabled
47 Brake Released at Stop
50 Output for CANopen control
51 Output for RS-485
52 Output for communication card
Example of crane function
CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
Active when frequency is ≤ Pr.02-32.
Active when PR.05-24 is less than Pr.05-23 and time is more than Pr.05-25.
Active when the actual output frequency is 0. (the drive should be at RUN mode)
Active when the actual output frequency is 0 or Stop.
Active when Pr.06-22 is ON.
Active when Pr.06-23 is ON.
Active when Pr.06-24 is ON.
Active when Pr.06-25 is ON.
Active when the output frequency reaches frequency setting or stop
This function needs to be used with Pr.06-61 ~ Pr.06-63
When drive stops, the corresponding multi-function terminal will be ON if the
frequency is less than Pr.02-32. After it is ON, it will be OFF when brake delay time
exceeds Pr.02-30.
FREQUENCY
COMMAND
RUN
MULTI -FUNCTION
OUTPUT MO 47
For CANopen communication output
For RS-485 output
For Modbus TC/IP Communication Card, Ethernet I/P Communication Card, and
communication control to do output
157
FREQUENCY
COMMAND
RUN
02-30
<
02-32
TIME
M33643
63-4528—04