Honeywell VFD CORE Installation Instructions Manual page 78

DEVICENET COMMUNICATION CARD
NET LED
LED status
Green light on
Red light on
Red light flashes
Orange light flashes
DEVICENET COMMUNICATION CARD
Features
1. Based on the high-speed communication interface of Honeywell HSSP protocol, able to conduct immediate control to the
VFD.
2. Supports Group 2 only connection and polling I/O data exchange.
3. For I/O mapping, supports Max. 32 words of input and 32 words of output.
4. Supports EDS file configuration in DeviceNet configuration software.
5. Supports all baud rates on DeviceNet bus: 125kbps, 250kbps, 500kbps and extendable serial transmission speed mode.
6. Node address and serial transmission speed can be set up on VFD.
7. Power supplied from the VFD.
Product introduction
63-4528—04
Indication
Normal status
PROFIBUS DP COMMUNICATION CARD
is not connected to PROFIBUS DP bus.
Invalid PROFIBUS communication
address
PROFIBUS DP COMMUNICATION CARD
fails to communication with VFD.
6 1 2 3 4
5 7
Action
No action required
Connect PROFIBUS DP COMMUNICATION CARD to
PROFIBUS DP bus.
Set the PROFIBUS address of PROFIBUS DP
COMMUNICATION CARD between 1 ~ 125 (decimal)
Switch off the power and check whether PROFIBUS DP
COMMUNICATION CARD is correctly and normally
connected to VFD.
8
M33580
78
1. NS indicator
2. MS indicator
3. POWER indicator
4. Positioning hole
5. DeviceNet connection port
6. Screw fixing hole
7. Fool-proof groove
8. VFD connection port