Chapter 6: Control Circuit Terminal - Honeywell VFD CORE Installation Instructions Manual

CHAPTER 6: CONTROL CIRCUIT TERMINAL

For multi-function input and output terminal, remove the top cover before wiring
The figures shown in the diagram below are for reference only.
Remove the cover for wiring. Frame A~E
Frame A & B
Loosen the screws and press the tabs on both sides to
remove the cover.
Screw torque: 12~15Kg-cm [10.4~13lb-in.]
Frame E
Screw torque: 12~15Kg-cm [10.4~13lb-in.] Slightly lift the cover, then pull outward for removal.
Frame C & D
Screw torque: 12~15Kg-cm [10.4~13lb-in.]
M33258
29
M33259
M33260
63-4528—04