Honeywell VFD CORE Installation Instructions Manual page 165

Repartir
03 - 09 Analog Input Gain 1 (AVI1)
03 - 10 Analog Input Gain 2 (ACI)
03 - 11 Analog Positive Input Gain 3 (AVI2)
03 - 12 Analog Input Filter Time (AVI1)
03 - 13 Analog Input Filter Time (ACI)
03 - 14 Analog Input Filter Time (AVI2)
Settings
• These input delays can be used to filter noisy analog signal
• When the setting of the time constant is too large, the control will be stable but the control response will be slow. When the
setting of time constant is too small, the control response will be faster but the control may be unstable. To find the optimal
setting, please adjust the setting according to the control stable or response status.
03 - 15 Addition Function of the Analog Input
Settings
• When Pr.03-15 is set to 0 and the analog input setting is the same, the priority for AVI1, ACI and AVI2 are AVI1>ACI>AVI2.
0.00~20.00 seconds
0: Disable (AVI1, ACI, AVI2)
1: Enable
FREQUENCY
[(AY ± BIAS)
F COMMAND GAIN]
*
F COMMAND: THE CORRESPONDING FREQUENCY FOR 10V OR 20 mA
AY: 10 OR 16mA
BIAS: PR.03-03, PR. 03-04, PR. 03-05
GAIN: PR.03-09, PR. 03-10, PR. 03-11
CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
VOLTAGE
F MAX (01-00)
*
10V OR 16 mA
M33661
165
Factory Setting: 0.01
Factory Setting: 0
63-4528—04