Honeywell VFD CORE Installation Instructions Manual page 152

CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
02 - 30 Brake Delay Time
Settings
• When the VFD runs after Pr.02-30 delay time, the corresponding multi-function output terminal (12: mechanical brake release)
will be ON. It is recommended to use this function with DC brake.
FREQUENCY
COMMAND
FREQUENCY
RUN / STOP
MULTI-FUNCTIONAL
OUTPUT (MECHANICAL
BRAKE RELEASE)
PR.02 -11 TO 02-14 12
MECHANICAL BRAKE
• If this parameter is applied without DC brake, it will be invalid. Refer to the following operation timing.
MULTI-FUNCTIONAL OUTPUT
(MECHANICAL BRAKE RELEASE)
PR.02-11 TO 02-14 12
MECHANICAL BRAKE
63-4528—04
0.000~65.000 seconds
07- 02
DC BRAKE TIME
DURING
START -UP
DC BRAKE
OUTPUT
02 -30 BRAKE
DELAY TIME
BRAKED
ZERO
SPEED
FREQUENCY
COMMAND
OUTPUT
FREQUENCY
RUN / STOP
BRAKE
A
B A
RUN
BOUNCE TIME OF
MECHANICAL BRAKE
RELEASE
A
B A
RUN
RELEASE
152
Factory Setting: 0.000
07-03
DC BRAKE TIME
DURING
STOPPING
DC BRAKE
STOP
BRAKED
TIME
M33641
ZERO
SPEED
STOP
BRAKE
TIME
M33642