Honeywell VFD CORE Installation Instructions Manual page 121

PUMP Parameters
Parameter
10-00 Circulative Control
Number of motors to be
10-01
connected
Operating time of each motor
10-02
(minutes)
Delay Time due to the
10-03 Acceleration (or the Increment )
at Motor Switching
Delay Time due to the
10-04 Deceleration ( or the Decrement)
at Motor Switching (seconds)
Delay time while fixed quantity
10-05 circulation at Motor Switching
(seconds)
Frequency when switching
10-06 motors at fixed quantity
circulation (Hz)
Action to do when Fixed Quantity
10-07
Circulation breaks down.
Frequency when stopping
10-08
auxiliary motor (Hz)
Table 11. Pump parameters
Explanation
0: No operation
1: Fixed Time Circulation (by time)
2: Fixed quantity circulation (by PID)
3: Fixed quantity control
4: Fixed Time Circulation+ Fixed quantity circulation
5: Fixed Time Circulation+ Fixed quantity control
From only 1 and up to 8 motors
0 to 65500 min
0.0 to 3600.0 sec
0.0 to 3600.0 sec
0.0 to 3600.0 sec
0.00 to 600.00 Hz
0: Turn off all output
1: Motors powered by mains electricity continues to
operate.
0.00 to 600.00 Hz
CHAPTER 11: SUMMARIES OF PARAMETER SETTINGS
Settings
121
Factory
Setting
0
1
0
10
10
100
6000
0
0
63-4528—04