Honeywell VFD CORE Installation Instructions Manual page 85

LED Indicators & Troubleshooting
There are 2 LED indicators on ETHERNET/IP COMMUNICATION CARD. The POWER LED displays the status of power supply,
and the LINK LED displays the connection status of the communication.
LED Indicators
LED Status
POWER Green
LINK Green
Troubleshooting
Abnormality
POWER LED off
LINK LED off
Poor contact to RJ-45 connector
No communication
card found
Fail to open
ETHERNET/IP
COMMUNICATION
CARD setup page
Able to open
ETHERNET/IP
COMMUNICATION
CARD setup page but
fail to utilize webpage
monitoring
Fail to send e-mail
On Power supply in normal status
Off No power supply
On Network connection in normal status
Flashes Network in operation
Off Network not connected
Cause
VFD not powered
ETHERNET/IP COMMUNICATION
CARD not connected to VFD
ETHERNET/IP COMMUNICATION
CARD not connected to network
ETHERNET/IP COMMUNICATION
CARD not connected to network
PC and ETHERNET/IP
COMMUNICATION CARD in different
networks and blocked by network
firewall.
ETHERNET/IP COMMUNICATION
CARD not connected to network
Incorrect communication setting in
DCISoft
PC and ETHERNET/IP
COMMUNICATION CARD in different
networks and blocked by network
firewall.
Incorrect network setting in
ETHERNET/IP COMMUNICATION
CARD
Incorrect network setting in
ETHERNET/IP COMMUNICATION
CARD
Incorrect mail server setting
Indication
Check if VFD is powered, and if the power supply is
normal.
Make sure ETHERNET/IP COMMUNICATION CARD is
connected to VFD.
Make sure the network cable is correctly connected to
network.
Make sure RJ-45 connector is connected to Ethernet port.
Make sure ETHERNET/IP COMMUNICATION CARD is
connected to network.
Search by IP or set up relevant settings by VFD keypad.
Make sure ETHERNET/IP COMMUNICATION CARD is
connected to the network.
Make sure the communication setting in DCISoft is set to
Ethernet.
Conduct the setup by VFD keypad.
Check if the network setting for ETHERNET/IP
COMMUNICATION CARD is correct. For the Intranet
setting in your company, please consult your IT staff. For
the Internet setting in your home, please refer to the
network setting instruction provided by your ISP.
Check if the network setting for ETHERNET/IP
COMMUNICATION CARD is correct.
Please confirm the IP address for SMTP-Server.
85
ETHERNET/IP COMMUNICATION CARD
Action
No action required.
Check the power supply.
No action required.
No action required.
Check if the network cable is connected.
Action
63-4528—04