Honeywell VFD CORE Installation Instructions Manual page 167

03 - 21 Gain for Analog Output 2 (AFM2)
Settings
• It is used to adjust the analog voltage level (Pr.03-17) that terminal AFM outputs.
• This parameter is set the corresponding voltage of the analog output 0.
03 - 22 Analog Output 2 Value in REV Direction (AFM2)
Settings
10 V (20 mA)
0 V
(0 mA)
03 -19
03 - 22
03 - 23 Display Low-Pass Filter AFM1, AFM1 Filter
03 - 24 Display Low-Pass Filter AFM2, AFM2 Filter
Settings
03 - 25 AVI1 Selection
0~500.0%
0: Absolute value in REV direction
1: Output 0V in REV direction; output 0-10V in FWD direction
2: Output 5-0V in REV direction; output 5-10V in FWD direction
03 -15
03 -18
03 - 21
0
0
Selections for the analog output direction
0.001~65.535 seconds
CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
10 V (20 mA)
0 V
FREQUENCY
(0 mA)
03 -19 1
03 - 22 1
167
Factory Setting: 100.0
Factory Setting: 0
10 V (20 mA)
5 V
FREQUENCY
(12 mA)
03 -19 2
03 - 22 2
M33662
Factory Setting: 0
Factory Setting: 0
63-4528—04