Honeywell VFD CORE Installation Instructions Manual page 73

CORE
Parameters
Set up source of frequency
00-20
Set up source of operation
00-21
Communication decoding
09-30
09-75
09-76
09-77
09-78
09-79
09-80
09-81
09-82
09-83
09-84
09-85
09-86
09-87
Remove Modbus TCP/IP communication card from VFD-CORE
1. Switch off the power supply of VFD CORE.
2. Remove the two screws (see Figure 6).
3. Twist opens the card clip and inserts the slot type screwdriver to the hollow to prize the PCB off the card clip (see Figure 7).
4. Twist opens the other card clip to remove the PCB (see Figure 8).
Functions
command
command
method
IP configuration
IP address-1
IP address-2
IP address-3
IP address-4
Net mask-1
Net mask-2
Net mask-3
Net mask-4
Default gateway-1
Default gateway-2
Default gateway-3
Default gateway-4
CHAPTER 8: INSTALLATION OF THE OPTION CARDS
Factory setting
(Dec)
0 Frequency command from keypad
5 Operation command from communication card.
0 The decoding method for Honeywell VFD
0 Static IP(0) / Dynamic IP (DHCP) (1)
192 IP address 192.168.1.5
168 IP address 192.168.1.5
1 IP address 192.168.1.5
5 IP address 192.168.1.5
255 Net mask 255.255.255.0
255 Net mask 255.255.255.0
255 Net mask 255.255.255.0
0 Net mask 255.255.255.0
192 Default gateway 192.168.1.1
168 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
1 Default gateway 192.168.1.1
73
Explanation
63-4528—04