Installer Setup; Thermostat Key Locations; Setup Using Keypad - Honeywell T7351 Installation Instructions Manual

T7351 COMMERCIAL PROGRAMMABLE THERMOSTAT

INSTALLER SETUP

For most applications, the thermostat factory settings do
not need to be changed. Review the factory settings in
Table 2.
NOTE: When power is first applied to the thermostat, the
display will show all segments (see Fig. 6).
Table 2. Default Setpoints.
Control Occupied
Heating 70° F (21° C) 55° F (13° C)
Cooling 75° F (24° C) 85° F (29° C)
Temporary Standby
Not Occupied12 StartTime
MonTueWedThuFri
System
Em Heat Off Cool Auto
Fig. 6. LCD display of all segments.
CAUTION
Possible Equipment Damage.
Fan must be running when system is
operating.
Heat pump and electric heat systems must be
configured correctly to prevent equipment damage
caused by the system running without the fan.
62-0258
Temperature
Occupied Not Occupied
HEAT COOL HEAT
Schedule
Day Occupied Not Occupied
Fig. 5. Thermostat key locations.
Not Occupied Standby
67° F (19° C)
78° F (26° C)
Set Set Schedule Room
AM
PM
MinsDays
SatSunHol
Fan
Dehumid OnAuto
Set Day/Time
Day Time
COOL
System
Clear
Start Time Copy
HEAT COOL

Setup Using Keypad

The installer uses the Installer Setup to customize the
thermostat to specific systems
A combination of key presses are required to use the
Installer Setup feature:
1. To enter the Installer Setup, press and hold both the
Run Schedule and the Copy keys until DEGREES
00 (or DEGREES 01) displays.
NOTE: Installer Setup will display WAIT and is
2. To advance to the next Installer Setup number,
press
NOTE: Pressing Run/Copy again while in this
%
3. To return to a Setup item, cycle through the options.
4. To change a setting, use the up ! or down " key.
5. To exit the Installer Setup, press Run Schedule.
M19611
6. Display prompts SAV CFG (save configuration).
a. If you want to save the new configuration, use
the up ! or down " key to change NO to YES
before pressing Run Schedule.
b. If you want the configuration to remain as it was
before starting this change, ensure the
display indicates SAV CFG NO and press Run
Schedule.
NOTE: Installer Setup is automatically exited after five
minutes with no key pressed. Upon this auto-
matic exit, all changes are lost.
Configuration
Configuration can be done with the keypad using the
Installer Setup (ISU).
4
Override
Temporary Temporary
Occupied Not Occupied
Fan Run
Schedule
ON AUTO
M19610
unavailable for 30 seconds after power up.
.
mode displays the T7351 firmware version
number.