Honeywell VFD CORE Installation Instructions Manual page 151

53 Triggered CANopen quick stop
UVW magnetic contactor ON/
OFF
Confirmation signal of released
55
brake
56 Max. Reverse Disabled
57 Max. Forward Disabled
Enable fire mode with RUN
58
Command
Enable fire mode without RUN
59
Command
60 Disable all the motors
61 Disable Motor#1
62 Disable Motor#2
63 Disable Motor#3
64 Disable Motor#4
65 Disable Motor#5
66 Disable Motor#6
67 Disable Motor#7
68 Disable Motor#8
CHAPTER 12: DESCRIPTION OF PARAMETER SETTINGS
Table 1. Table of Functions (Continued)
When this function is triggered under CANopen control, the drive will change its
status to quick stop.
To receive confirmation signals while there is UVW magnetic contactor during output.
When a motor has a mechanical brake, this function is to confirm a brake has been
released.
To set maximum value while Reverse and Forward operations have a limit switch to
do reciprocating actions.
Enable this function under fire mode to force the drive to run (while there is RUN
COMMAND).
Enable this function under fire mode to force the drive to run (while there isn't RUN
COMMAND).
If any of Auxiliary Motor#1 to Motor#8 is out of order or under maintenance, enable
this terminal to bypass that motor.
151 63-4528—04