Beacon Mode; If The Hp D2D Backup System Is New And Not Yet Configured; If The Hp D2D Backup System Has Been Configured Incorrectly; If The Network Setup Has Been Changed - HP StorageWorks D2D100 - Backup System User Manual

Beacon mode

The HP D2D Backup System supports a Beacon LED sequence, which helps a user identify which unit is
being configured, if several are connected to the network. See also "LEDs" on page 57.
If the HP D2D Backup System is new and not yet configured
When installing the HP D2D Backup System for the first time, this step must be completed successfully
before you can connect from your host. Select the appropriate HP D2D Backup System from the list
and make a note of its IP address because you will need this when you configure the iSCSI Initiator,
see also "Discovery
If the HP D2D Backup System has been configured incorrectly
If you cannot connect to the HP D2D Backup System using the Web Management interface, it may
have been configured incorrectly. Run the Discovery Engine to check the IP address of the HP D2D
Backup System and, if necessary, select it again from the list of available HP D2D Backup Systems.
If you still cannot connect to it, check that you have configured the iSCSI Initiator correctly, see also
"Discovery tab" on page 52.

If the network setup has been changed

If the network infrastructure changes, you may need to update the HP D2D Backup System network
settings to allow hosts to continue to connect. Run the Discovery Engine and change the network settings
in accordance with your new infrastructure.
You can also use the Web Management Interface to modify these settings directly on the HP D2D Backup
System, as long as this is done before the infrastructure changes are made.
Once the network settings of the HP D2D Backup System have been changed, you must also change the
iSCSI Initiator for each host.
Using the console to discover the HP D2D Backup System
(IPv4 and IPv6)
If you do not use the Installation Wizard or it fails, you can connect the system console directly to the
unit in order to find out the IP address.

To connect the system console

1.
Connect the monitor cable to the VGA port on the rear of the unit.
tab" on page 52.
D2D Backup System HP D2D2503
47