Replacing A Hot-Plug Hard Disk - HP StoreOnce B6000 Series User Manual

Replacing a hot-plug hard disk

1. Identify the disk that has failed as described above.
NOTE:
controller or expansion shelves.
2. Remove the disk.
Press the hard disk carrier button (1) to release the ejector lever.
Pull out the disk carrier handle (2) and slide the hard drive assembly (3) out of the drive
bay. Be sure to support the drive when pulling it out of the cage.
Figure 1 1 Removing the hard drive
3. Replace the failed disk with the new disk.
Push the hard drive assembly (1) into the drive bay until it stops and press the HDD carrier
latch (2) inward until it clicks.
Figure 12 Installing a replacement hard disk
Remember you can use the Beacon LED to identify the physical disk in the storage
Hard disk replacement 135