Dell 3115 Color Laser User Manual page 569

During g
Pay attention to the following points during p
Using lp/lpr Command (Linux/Solaris/HP-UX)
If an option is specified incorr o error message will be output. If printing is not executed
after th lp command is executed, activat tility individually and error messages will
be output.
(Using Solaris, the error message i on the screen. Using Linux, the error message is
written into the g file specified by printcap.)
In text printing vironmental variable TXT2PS2OPTION will be ignored.
t printing, if a BS code is found at the beginning of a line, the ion of the next character
will be on the left of the beginning of
In text printing, when there are multiple ta in one line, the positions of tab may be off
due to automatic line this happens, specify l or w option.
xt printing, the number of columns specified by the w option does not reflect the number
of characters printed. The actual number of single-byte characters to be printe ived
by deducting the output column position (out columns) specified o option from the
number of specified by the w option
If the same option is specified, or s, are both specified, the one specified later will
prevail.
In printing f the print position option (l specifies an area beyond the printable area of
the multifunction pr ata beyond the printable area will not be printed. (Using Solaris,
i ssible to output images by lp ommand.)
Using txt2ps2 (Linux/Solaris/HP-UX)
When the same option is specified he later setting will prevail. As TXT2 is analyzed
before the option of the command line, it i e to temporarily modify the options
already set in TXT2PS2OPTION by inputting at the command line
The defa ut of txt2ps2 cannot output the comment description (%%page:m n)of the page
number. This is because th ed PostScript language program controls line feed and
form feed. Thu the output of txt2ps2 is to be taken as the output of another applica
rev of TRANSCRIPT, etc.), e number description by inserting the line command (-
Ines).
If a BS code is found at the beginning of a line, t osition of the next character will be on
the left of the beginning
When there are multiple tab codes in one line, the posi tab may be off due to automatic
line feed. If this happens, speci -l or -w option.
The number of columns spe y the -w option does not re number of characters actually
printed. The actual number of single- racters to be printed is derived by deducting
the output column posi t columns) specified by the o from the number of columns
specified by the w option.
The -mg option cannot be specified when -w, -l, -o, and option are specified.