Network Protocols - Dell 3115 Color Laser User Manual

2. Press until >Admin Menu nd then press
3. Press >Admin Reports appears, press
4. ess unti >Server Address appears, and ress
ork Configuration page prints out.
S Network Protocols
When you first install tifunction printer, all supported network protocols are enabled w er the
multifunction printer on. If a network protocol is enabled, tifunction printer may actively
transmit on the network even when th ol is not in use. This may slightly increase network
traffic. To elim ecessary traffic, you can disable unused protocols.
1. Press until >SETUP appears, and then press
2. Press until >Adm appears, and then press
3. Press until >Wired Net or >Wireless Net ap then press
4. Press until >Protocol appears, and then press
5. Press to select the desired settings, and then

Port9100

FTP

P

E-Mail A

EWS
Configuring TCP/IP

ddressing: TCP/IP address is assigned manually by the system adminis

Dynamic Addre OTP/DHCP(default): TCP/IP address is assigned automatically by a
DH OTP server on your network.
St ressing
To enter the TCP/IP address from yo function printer's operator panel, take the following
steps:
1. Press until >SETUP appears, and then press
.
.
.
.
.
.
.
.