Dell 3115 Color Laser User Manual page 217

IPv4 Get IP
Address
IP Address
Subnet Mask
Gateway Address
2
Res *
1
* Only displayed tional multi-protocol card is installed on the printer.
2
* Only displayed when enabled.
3
* This mode is available hen firmware version 200706291103 or later and network (MPC) f
version 16.03 or later are installed. Since you cannot set IPs indows Vista in this mode, use
the Del Configuration Web Tool. The G mation from Printer function on the ions tab of
the printer driver is not available when is mode.
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the printer i off and then
on again.
Values:
LPD Enable*
Disable
Port9100 E
Disable
1
IPP* Enable*
Disable
AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set address.
RARP Uses RARP to set the IP address.
P Uses DHCP to set the IP address.
Panel E the IP address entered on the operator panel.
Sets the IP address allocated to the printer by
he keys on the operator panel.
Sets the subne
Sets the gateway address.
Disables IPs
Enables the LPD port.
Disables the LPD port.
E he Port9100 port.
Disables the Port9100 port.
Enables the IPP port.
Disables the IPP port.