Defining Ipv4 Interface (Layer 2) - Cisco SGE2000 - - Gigabit Switch Administration Manual

Configuring IP Information
IP Addressing
STEP 1
Cisco Small Business SFE/SGE Managed Switches Administration Guide
•
Defining DHCP Relay (Layer 3)
•
ARP

Defining IPv4 Interface (Layer 2)

IPv4 Interface Page
The
forwarded to the default IP when frames are sent to a remote network. The
configured IP address must belong to the same IP address subnet of one of the IP
interfaces.
Click System > System Management > IP Addressing > IPv4 Interface. The
Interface Page
opens:
IPv4 Interface Page
IPv4 Interface Page
The
•
Supported IP Format — Displays the supported IP format: Version 4.
•
Get Dynamic IP from DHCP Server — Retrieves the IP addresses using DHCP.
•
Static IP Address — Permanent IP addresses are defined by the administrator.
IP addresses are either configured on the Default VLAN or are user-defined.
•
Management VLAN — Sets the management VLAN. The Management VLAN is
used to access the switch through telnet and / or the web GUI. Management
VLAN is set to 1by default.
contains fields for assigning IPv4 addresses. Packets are
contains the following fields:
7
IPv4
205