Cisco SGE2000 - - Gigabit Switch Administration Manual page 269

Configuring Spanning Tree
Defining Spanning Tree
Cisco Small Business SFE/SGE Managed Switches Administration Guide
-
Backup
— Provides a backup path to the designated port path toward
the Spanning Tree leaves. Backup ports occur only when two ports are
connected in a loop by a point-to-point link. Backup ports also occur
when a LAN has two or more connections connected to a shared
segment.
-
Disable
— Indicates the port is not participating in the Spanning Tree.
•
Mode — Indicates the current Spanning Tree mode. The possible field values
are:
-
STP
— Indicates that Classic STP is enabled on the port.
-
Rapid STP
•
Fast Link — Indicates if Fast Link is enabled or disabled for the port or LAG. If
Fast Link is enabled for a port, the port is automatically placed in the
forwarding state. The possible field values are:
-
Enable — Fast Link is enabled.
-
Disable
— Fast Link is disabled.
-
Auto
— Fast Link mode is enabled a few seconds after the interface
becomes active.
•
Port Status — Indicates the RSTP status on the specific port. The possible field
values are:
-
Disabled
— Indicates that STP is currently disabled on the port.
-
Blocking
— Indicates that the port is currently blocked and cannot
forward traffic or learn MAC addresses.
-
Listening
— Indicates that the port is in Listening mode. The port cannot
forward traffic nor can it learn MAC addresses.
-
Learning
— Indicates that the port is in Learning mode. The port cannot
forward traffic, however it can learn new MAC addresses.
-
Forwarding
can forward traffic and learn new MAC addresses.
•
Point-to-Point Operational Status — Indicates the Point-to-Point operating
state. The possible values are:
-
Enable — Enables Point-to-Point on the interface.
-
Disable — Disables Point-to-Point on the interface.
— Indicates that Rapid STP is enabled on the port.
— Indicates that the port is in Forwarding mode. The port
10
260