Modifying Gvrp Settings - Cisco SGE2000 - - Gigabit Switch Administration Manual

Configuring VLANs
Defining GVRP Settings
STEP 2
STEP 3
STEP 1
STEP 2
Cisco Small Business SFE/SGE Managed Switches Administration Guide
•
Copy From Entry Number — Copies GVRP parameters from the specified
table entry.
•
To Entry Number(s) — Assigns the copied GVRP parameters to the specified
table entry.
•
Ports of Unit — Indicates the port number and stacking member for which
GVRP parameters are displayed.
•
LAGs — Indicates the LAG number for which GVRP parameters are displayed.
•
Interface — Interface described by the GVRP settings entry.
•
GVRP State — Indicates if GVRP is enabled on the interface. The possible field
values are:
-
Enabled
— Enables GVRP on the selected interface.
-
Disabled
— Disables GVRP on the selected interface.
•
Dynamic VLAN Creation — Indicates if Dynamic VLAN creation is enabled on
the interface. The possible field values are:
-
Enabled
— Enables Dynamic VLAN creation on the interface.
-
Disabled
— Disables Dynamic VLAN creation on the interface.
•
GVRP Registration — Indicates if VLAN registration through GVRP is enabled
on the device. The possible field values are:
-
Enabled
— Enables GVRP registration on the device.
-
Disabled
— Disables GVRP registration on the device.
Define the relevant fields.
Click Apply. The GVRP Settings are defined, and the device is updated.

Modifying GVRP Settings

Click Bridging > VLAN Management > GVRP Settings. The
opens:
Click the Edit button. The Edit GVRP Page opens:
6
GVRP Settings Page
174