Cisco SGE2000 - - Gigabit Switch Administration Manual page 124

48-port 10/100/1000 sfe/sge managed switches
Hide thumbs Also See for SGE2000 - Cisco - Gigabit Switch:
Table of Contents

Advertisement

Configuring Device Security
Defining Access Control
Cisco Small Business SFE/SGE Managed Switches Administration Guide
-
EIGRP
Enhanced Interior Gateway Routing Protocol
fast convergence, support for variable-length subnet mask, and
supports multiple network layer protocols.
-
OSPF
— The
hierarchical Interior Gateway Protocol (IGP) for network routing Layer
Two (2) Tunneling Protocol, an extension to the PPP protocol that
enables ISPs to operate Virtual Private Networks (VPNs).
-
IPIP
IP over IP
between two routers. This ensure that IPIP tunnel appears as a single
interface, rather than several separate interfaces. IPIP enables tunnel
intranets occur the internet, and provides an alternative to source
routing.
-
PIM
— Matches the packet to
-
L2TP
— Matches the packet to
-
ISIS
Intermediate System - Intermediate System
routing information throughout a single Autonomous System in IP
networks.
-
ANY
— Matches the protocol to any protocol.
Source Port — Defines the TCP/UDP source port to which the ACE is matched.
This field is active only if 800/6-TCP or 800/17-UDP are selected in the Select
from List drop-down menu. The possible field range is 0 - 65535.
Dest. Port — Defines the TCP/UDP destination port. This field is active only if
800/6-TCP or 800/17-UDP are selected in the Select from List drop-down
menu. The possible field range is 0 - 65535.
Flag Set — Sets the indicated TCP flag that can be triggered.
ICMP Type — Filters packets by ICMP message type. The field values is 0-255.
ICMP Code — Indicates and ICMP message code for filtering ICMP packets.
ICMP packets that are filtered by ICMP message type can also be filtered by
the ICMP message code.
Source
-
IP Address — Matches the source port IP address to which packets are
addressed to the ACE.
-
Prefix Length — Defines the IP route prefix for the destination IP. The
prefix length must be preceded by a forward slash /.
Open Shortest Path First
(IPIP). Encapsulates IP packets to create tunnels
Protocol Independent Multicast
Layer 2 Internet Protocol
(EIGRP). Provides
(OSPF) protocol is a link-state,
(L2IP).
(ISIS). Distributes IP
4
(PIM).
115

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sge2000pSge2010Sfe2010Sfe2000

Table of Contents