Device And The Client In Both Directions Simultaneously; Half - Indicates That The Interface Supports Transmission Between The Device And The Client In Only One Direction At A Time - Cisco SGE2000 - - Gigabit Switch Administration Manual

Configuring Ports
Configuring Ports Settings for Layer 2 Enabled Devices
Cisco Small Business SFE/SGE Managed Switches Administration Guide
-
Down — Indicates the port is currently not operating.
•
Current Port Status — Displays the port connection status.
•
Suspended Port — Reactivates a port if the port has been disabled through
the locked port security option or through Access Control List configurations.
•
Operational Status — Indicates whether the port is currently active or inactive.
•
Admin Speed — Displays the configured rate for the port. The port type
determines what speed setting options are available. You can designate Admin
Speed only when the port auto-negotiation is disabled.
•
Current Port Speed — Displays the current port speed.
•
Admin Duplex — Defines the port duplex mode. This field is configurable only
when auto negotiation is disabled, and the port speed is set to 10M or 100M.
This field cannot be configured on LAGs. The possible field values are:
-
Full
— Indicates that the interface supports transmission between the

device and the client in both directions simultaneously.

-
Half
— Indicates that the interface supports transmission between the
device and the client in only one direction at a time.
•
Current Duplex Mode — Displays the port current duplex mode.
•
Auto Negotiation — Enables Auto Negotiation on the port. Auto Negotiation
enables a port to advertise its transmission rate, duplex mode and flow control
abilities to its partner.
•
Current Auto Negotiation — Displays the Auto Negotiation status on the port.
•
Admin Advertisement — Specifies the capabilities to be advertised by the
Port. The possible field values are:
-
Max Capability
settings can be accepted.
-
10 Half
— Indicates that the port is advertising a 10 mbps speed and
half Duplex mode setting.
-
10 Full
— Indicates that the port is advertising a 10 mbps speed and full
Duplex mode setting.
-
100 Half
— Indicates that the port is advertising a 100 mbps speed and
half Duplex mode setting.
-
100 Full
— Indicates that the port is advertising a 100 mbps speed and
full Duplex mode setting.
— Indicates that all port speeds and Duplex mode
5
155