Image Formation System; Adjusting The Tension On The Drive Belt Of The Transfer Belt Motor; Adjusting The Height Of The Charging Wire - Canon CLC5100 Series Manual

Chapter 2

2.5 Image Formation System

2.5.1 Adjusting the Tension
on the Drive Belt of the
Transfer Belt Motor
CLC5100 / CLC4000
1) Make adjustments so that the gap of the adjusting
screw [1] of the transfer belt motor is 3.5 ±0.3 mm.
F-2-38
2.5.2
Adjusting
Position of the Transfer
Belt Related Solenoid
CLC5100 / CLC4000
a. Adjusting the Position of the Transfer Blade
Solenoid (SL7)
Fix the solenoid in place so that the distance between
the solenoid arm and the solenoid mount base is 17.8
±0.3 mm when the plunger of the solenoid is pulled.
F-2-39
2-20
0002-4273
[1]
3.5±0.3mm
the
0002-5740
17.8 0.3mm
b. Adjusting the Position of the Oil Removing Roller
Solenoid (SL18)
Fix the solenoid in place so that the stroke indicated in
the following Figure is 2.5 ±0.3 mm when the
solenoid arm is pulled by the spring.
F-2-40
2.5.3 Adjusting the Height
of the Charging Wire
CLC5100 / CLC4000
Charging
Height of charging wire (mm)
assembly
Primary
charging
assembly
Separation
charging
assembly
Pre fixing
charging
17±0.3
assembly
2.5 0.3mm
0002-5765
T-2-2
Variable
width
4 mm
(approx.)
10.5±0.2
4 mm
16.5±0.3
(approx.)
4 mm
(approx.)