Cabling The Atm Coax (Ds3/E3) Connectors; Attaching A Redundant Power System - 3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual

Attaching a
Redundant Power
System
Wall outlet

Cabling the ATM Coax (DS3/E3) Connectors

You can cable the ATM Coax (DS3/E3) connectors using two 75-ohm
coaxial (BNC) cables as shown here.
OC3/3
Select
Link
Active
Fault 100Mb
You can attach your PathBuilder switch to a PathBuilder Redundant
Power System (RPS).
PathBuilder switch
Power cable
Power cable
For full power supply redundancy, attach one end of the RPS cable to the
rear panel on the switch and the other end to the RPS. Then attach one

Attaching a Redundant Power System

Link
Coax 3
Active
Rx Tx
Select
Fault
Link
LAN 1
Active
Fault 100Mb
PathBuilder Redundant Power System
RPS cable
Console
LAN 2
75-ohm coaxial (BNC) cables
33