3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual page 152

152 A G: C
PPENDIX OMPLETING
Add -SYS InstanceGRoup E1FATPA "!4A.1, !4B.1, !4C.1, !4D.1" PAth
# Connector-level path parameter configuration
# The following parameter settings are only typical example settings.
# Your network-specific settings need to be assigned by consulting the
# connector-level path parameter documentation in the document
# "Using the PathBuilder Switch"
SETDefault !E1FAT -PAth FrameMode
SETDefault !E1FAT -PAth CONNector
SETDefault !E1FAT -PAth LineCoding
SETDefault !E1FAT -PAth LineDistance = SH7
SETDefault !E1FAT -PAth CLock
# Path-level path parameter configuration
# The following parameters may need to be changed from their default
# settings, based on your specific environment topology:
#
# ChannelMap: This parameter specifies the timeslots (i.e. channels)
# associated with the specified path.
# for path 4A.1 to map to all 31 timeslots (1 through 31)
# on connector 4A, 4B.1 to map to all 31 timeslots on
# connector 4B, etc.
# If all timeslots will not be used, this parameter setting
# will need to be changed via the DELete command, as
# shown below.
# back channels.
# ChannelBaud: This parameter specifies the baud rate (56K or 64K) of
# each timeslot (i.e. channel) mapped to the
# specified path.
# This setting can be changed to CB56K (56kbits/sec) for
# leased-line paths that require 56kbit/sec operation
#
# Some examples on changing these parameter settings are:
#
# DELete !E1FATPA -PAth ChannelMap 1,2,3,7,12,30
# ADD !E1FATPA -PAth ChannelMap 1,2,3,7,12,30
# SETDefault !E1FATPA -PAth ChannelBaud = CB56K
# Enable Connectors
SETDefault !E1FAT -PAth ConnControl = Enable
# Assign all timeslots to the connectors
ADD !E1FATPA -PA ChannelMap
ADD !E1FATPA -PA ChannelMap 11,12,13,14,15,16,17,18,19,20
ADD !E1FATPA -PA ChannelMap 21,22,23,24,25,26,27,28,29,30,31
SETDefault !E1FATPA -PAth Control = Enable
T U -WAN C
HE LTRA ONFIGURATION
= E1_CRC4
= E1_Unstructured
= HDB3
= External
Note that the ADD command is used to add
Default setting is CB64K (64kbits/sec).
1, 2, 3, 4, 5, 6, 7, 8, 9,10
Default setting is