Shutting Down - 3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual

Shutting Down

3 Verify that configurable parameters of your device match the
configuration settings of the console port specified in Table 8.
Table 8 Console Port Configuration Settings
Characteristic
Baud rate
Databits
Parity
Stop bits
DTR
Duplex
Echo
Flow control
4 Turn on the device.
If your PathBuilder switch is not connected to an RPS, turn off the power
by pressing the off (0) side of the power switch on the back panel. If your
system is connected to an RPS, turn off the power by unplugging the RPS
cable from the system and then pressing the off (0) side of the power
switch.
Setting
9600
8
None
1
Ignored
Full
Off
X-on/X-off
Shutting Down 35