Boot; Configure Flash Load; Clear Pid - 3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual

112 A E: T
PPENDIX ROUBLESHOOTING

Boot

Syntax
Description
Configure Flash Load
Syntax
Description

Clear PID

Syntax
Description
BT [<filename> [<boot_drive:path>]]
The BT command allows you to reboot or to override the default boot
path configured in the firmware by the monitor or by the SysconF
command in the software. If you enter a new boot drive or path, the
firmware parameter is updated to reflect the new path.
If you do not enter a filename or a configuration file directory, the system
attempts to boot using the boot.ppc file referenced by the boot directory
in the primary boot source. If there is an error, a message is sent to the
console and you are returned to the monitor utility.
Errors include:
The file does not exist.
The file has the wrong format.
The file has a bad checksum.
CL
The CL command allows you to configure the following settings to
identify a TFTP server for downloading a boot image:
1. Client
2. Server
3. Gateway
4. Subnet Mask
5. Boot Filename
6. Port Selection
7. Baud Rate
8. Duplex Mode
CP
The CP command erases the Product ID (PID) except for the MAC
address.
CAUTION: The CP command erases the PID except for the MAC
address. You should only do this if advised by 3Com technical support.