3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual page 154

154 A G: C
PPENDIX OMPLETING
#
#
#
#
# (Note that the Rate Adaption path parameter is not applicable for
# for E1 PRI. All outbound calls attempt connection only at 64K.)
#
# Some examples on changing the LocalDialNo parameter setting are:
#
# SETDefault !E1PRI4A -PAth LocalDialNo = "4085551212"
# SETDefault !E1PRI4B -PAth LocalDialNo = "4085555555"
Example 9.
########################################################################
########################################################################
# ULTRAWAN CONNECTOR CONFIGURATION FILE
# E1 LEASED, CHANNELIZED TEMPLATE
# HOW TO CONFIGURE MULTIPLE CONNECTORS SIMULTANEOUSLY
# This example shows how to configure connectors 4A, 4B, 4C, and 4D
# simultaneously by creating groups of connectors and paths via the
# Instance Group command. To specify which connectors and paths are
# included in this grouping, just add or delete the according references
# in the Instance Group command.
# connectors 4A and 4C, the commands would look like the following:
# Add -SYS InstanceGRoup E1CHAN "!4A, !4C" PAth
# Add -SYS InstanceGRoup E1CHAN1 "!4A.1, !4C.1" PAth
# Add Instance Groups to cover all 4 UltraWAN connectors
###### Note: E1CHAN is short for E1, leased, CHANnelized
Add -SYS InstanceGRoup E1CHAN "!4A, !4B, !4C, !4D" PAth
# Connector-level path parameter configuration
# The following parameter settings are only typical example settings.
# Your network-specific settings need to be assigned by consulting the
# connector-level path parameter documentation in the document
# "Using the PathBuilder Switch"
SETDefault !E1CHAN -PAth FrameMode
SETDefault !E1CHAN -PAth CONNector
SETDefault !E1CHAN -PAth LineCoding
SETDefault !E1CHAN -PAth LineDistance = SH7
SETDefault !E1CHAN -PAth CLock
# Enable Connectors ( Note: path range instance groups require this 1st )
SETDefault !E1CHAN -PAth ConnControl = Enable
# Add Instance Groups to cover paths on all 4 UltraWAN connectors
T U -WAN C
HE LTRA ONFIGURATION
phone number, you will need to set this parameter
for each path that will support outbound calls.
There is no default setting for this parameter.
For example, to include only
= E1_CRC4
= E1_Channelized
= HDB3
= External