Ommands And; Connector And Path Level Command Syntax - 3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual

I
Connector and Path
Level Command
Syntax
C

OMMANDS AND

F U
OR LTRA
I
NTERFACES
This appendix describes the various commands and parameters related to
configuring and checking status on the Ultra-WAN CSU/DSU connectors.
The first section addresses connector-level path command syntax for
Ultra-WAN CSU/DSU connectors and how it is different from path
command syntax.
The second section explains in detail each of the connector-level path
commands and parameters needed to configure or monitor status on an
Ultra-WAN connector on a model S590/S598 PathBuilder switch.
The third section lists the new path parameters.
Connector-level path parameters differ from other path parameters in the
level of impact on the system. For connectors carrying only one path, the
impact and the usage model is the same for all path parameters.
However, for connectors carrying more than one path, the level of impact
and the usage models are different. Ultra-WAN CSU/DSU connectors can
be configured in single-path and multiple-path modes of operation.
In the multiple-path ISDN PRI dial configuration, connector-level
parameter settings effect all paths carried over the specified connector.
For example, disabling the connector disables all the paths on that
connector.
P
ARAMETERS
-WAN CSU/DSU