Completing The Installation Of A Drive - HP Kayak XA User Manual

mamdt.bk : mamdt2.fb4 Page 47 Tuesday, August 5, 1997 4:20 PM
Completing the
Installation of a SCSI
Drive
Completing the
Installation of an IDE
Drive

Completing the Installation of a Drive

1 Make sure you have set a unique SCSI address for the new device
(this is done automatically with Plug-and-Play drives).
2 Make sure that proper SCSI bus termination is established.
3 Make sure that all the SCSI cable connections are secure.
4 Turn on the display and then turn on the computer.
5 When the SCSI BIOS initialization messages are displayed, check
that the details for the new SCSI drive have been correctly detected.
6 Refer to the operating system documentation for information on
formatting a drive (if necessary), or refer to the installation guide
that came with the drive to see if you need to install some driver
software.
7 If you experience any problems as a result of the upgrade, refer to
Chapter 3, starting on page 55.
1 Make sure that all the IDE cable connections are secure.
2 Turn on the display and then turn on the computer.
3 The new drive is automatically detected and configured. If you want
to check this, press the
bottom of the screen. This displays a summary screen showing the
PC Workstation's configuration details.
If the drive is not recognized, or you want to change the boot order
of drives, run the Setup program: restart the PC Workstation and
press while
F2 Setup
4 Refer to the operating system documentation for information on
formatting a drive (if necessary), or refer to the installation guide
that came with the drive to see if you need to install some driver
software.
5 If you experience any problems as a result of the upgrade, refer to
Chapter 3, starting on page 55.
2 Installing Accessories in Your PC Workstation
Installing Mass Storage Devices
key while is displayed at the
F2 Setup
is displayed.
English 47