Switchcfgspeed - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

switchCfgSpeed

Configures all ports of a switch to a particular speed.
Synopsis switchcfgspeed speed_level
Description Use this command to configure the speed of all the ports on a switch to a particular level. The
configuration is saved in flash memory and persists across switch reboots or power cycles. If any
port on the switch is not capable of the specified speed setting, an error message displays for that
port.
The output of portShow displays the achieved speed level and portCfgSpeed displays the user's
desired speed setting.
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operand:
speed_level
Examples To set the speed level for all ports on a switch:
See Also portCfgSpeed, portShow
Fabric OS Command Reference
53-1000599-01
Specify the speed of a port. This operand is required. Valid values are one of
the following:
0 Auto sensing mode. The port automatically configures for the highest
speed.
1 1-Gbit/sec mode. The port is fixed at 1 Gbit/sec.
2 2-Gbit/sec mode. The port is fixed at 2 Gbit/sec.
4 4-Gbit/sec mode. The port is fixed at 4 Gbit/sec.
8 8-Gbit/sec mode. The port is fixed at 8Gbit/sec.
switch:admin> switchcfgspeed 0
Committing configuration...done.
2
switchCfgSpeed
621