Fcippathtest - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual
Brocade fabric os command reference guide v6.0.0 (53-1000599-01, april 2008)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Reference manual (1240 pages) ,
- Command reference manual (894 pages) ,
- Reference (550 pages)
Table of Contents
Advertisement
2
fcipPathTest
fcipPathTest
Tests data path of the FCIP complex.
Synopsis
fcippathtest [--slot slotnumber][-unit number][-path mode][-nframes count][-length data_length]
[-compress mode]
Description
Use this command to verify the data paths in the FCIP complex. All data path modes run tests by
comparing Fibre Channel frames or data packets transmitted from and received by the network
processor due to the designated loopback.
This command is supported only on Brocade FR4-18i blades and Brocade 7500 platforms.
Operands
This command has the following operands:
--slot slotnumber
-unit number
-path mode
-nframes count
-length data_length
-compress mode
Examples
To run the test on slot 2 with PHY loopback sending 10 frames:
158
Specifies the slot number on which the diagnostic operates. The default is 0
and operates on fixed-port-count products.
Specifies the GbE port to test. By default, all GbE ports in the specified
slotnumber are used. Valid number values include:
0
GbE port 0
1
GbE port 1
2
All GbE port
Specifies the loopback point for the test. By default, fcipPathTest uses PHY
and central ASIC loopback. Valid mode values include:
1
SFP loopback
2
PHY loopback
3
FCIP FPGA GMAC loopback
4
FCIP FPGA FC loopback
5
Central ASIC FC loopback
7
SFP and central ASIC FC loopback
8
PHY and central ASIC FC loopback
9
FCIP FPGA GMAC and central ASIC FC loopback
Specifies the number of frames to send. The test progresses until the
specified number of frames are transmitted on each port. The default value is
100.
Specifies the data length of the frames used in the test. The default is 1,024;
the maximum is 2,112 FC frames and 8,196 data packets.
Specifies the compression device to select or to bypass data compression for
the test. By default, data compression is used. This setting is applicable only
to path mode 1 and 2.
switch:admin> fcippathtest
slot 2 -path 2 -nframes 10
--
Fabric OS Command Reference
53-1000599-01
Advertisement
Table of Contents
