Portcfgalpa - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

portCfgAlpa

Configure the AL_PA offset on a specified port.
Synopsis portcfgalpa [slotnumber/]portnumber, mode
Description Use this command to set the Arbitrated Loop Physical Address (AL_PA) offset on a port to either
0x0 or 0x13.
Changes made by this command are persistent across switch reboots and power cycles.
Operands When invoked without operands, this command displays the usage. The following operands are
supported:
slotnumber
portnumber
mode
Examples To configure a port with AL_PA 0x0 (default):
To configure a port with AL_PA 0x13:
See Also portCfgShow
Fabric OS Command Reference
53-1000599-01
For bladed systems only, specify the slot number of the port to be configured,
followed by a slash (/).
Specify the number of the port to be configured, relative to its slot for bladed
systems. Use the switchShow command for a list of valid ports.
Specify a value of 1 to set the AL_PA to 0x13. A value of 0 sets the default
AL_PA of 0x0. This operand is required.
switch:admin> portcfgalpa 1/3 0
switch:admin> portcfgalpa 1/3 1
2
portCfgAlpa
435