Setsfpmode - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

Brocade fabric os command reference guide v6.0.0 (53-1000599-01, april 2008)
Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:
Table of Contents

Advertisement

2

setSfpMode

setSfpMode
Enables or disables media mode.
Synopsis
setsfpmode [mode | -show]
Description
Use this command to enable SFP media mode if the mode value is nonzero and disable the media
mode if the mode value is 0. The mode is saved in flash memory and stays in that mode until the
next execution of setSfpMode. The mode becomes active as soon as this command is executed. It
does not require a reboot to take effect.
Media mode modifies the behavior of the diagnostic test methods so that ports without media
installed are not tested. Diagnostic tests fail if any port is not operating properly, but with media
mode enabled, the functional tests are skipped on ports that do not contain media.
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands
This command has the following operands:
mode
-show
Examples
To enable, disable, and then display the media mode:
See Also
itemList, miniCycle, setGbicMode, setMediaMode
576
Specify 1 to enable media mode or 0 to disable media mode. If no mode is
specified, the current value is displayed. Any other value will enable media
mode.
Specify the -show operand to display the current setting. This operand is
optional.
switch:admin> setsfpmode 0
SFP mode is now 0 (disabled).
Fabric OS Command Reference
53-1000599-01

Advertisement

Table of Contents
loading

Table of Contents