Setmediamode - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

setMediaMode

Enables or disables media mode.
Synopsis setmediamode [mode | -show]
Description Use this command to enable media mode if the mode value is nonzero and disable the media
mode if the mode value is 0. The mode is saved in flash memory and stays in that mode until the
next execution of setMediaMode. The mode becomes active as soon as this command is executed.
It does not require a reboot to take effect.
Media mode modifies the behavior of the diagnostic test methods so that ports without media
installed are not tested. Diagnostic tests may fail if any port is not operating properly, but with
media mode enabled, the functional tests are skipped on ports that do not contain media.
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
mode
-show
Examples To display the media mode:
See Also itemList, miniCycle, setGbicMode, setSfpMode
Fabric OS Command Reference
53-1000599-01
Specify 1 to enable media mode or 0 to disable media mode. If no mode is
specified, the current value is displayed. Any other value will enable media
mode.
Specify the -show operand to display the current setting. This operand is
optional.
switch:admin> setmediamode -show
Media mode is now 0 (disabled).
2
setMediaMode
573