Ipaddrshow - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

ipAddrShow

ipAddrShow
Displays the IP address information for a switch or control processor (CP).
Synopsis ipaddrshow [-cp cp_number]
ipaddrshow [-sw sw_number]
ipaddrshow - slot n
ipaddrshow [-eth0 -eth1 -gate]
Description Use this command to display the IP addresses configured in the system.
The -cp option displays the CP IP address and the -sw option displays the switch IP addresses. For
switches, the command displays the Ethernet IP address, Ethernet subnetmask, Fibre Channel IP
address, and Fibre Channel subnetmask. For CPs, the command displays the Ethernet IP address,
Ethernet subnetmask, host name, and gateway IP address.
For chassis based systems with intelligent blades the addresses configured for each slot can be
shown with the -slot option. Without any further options it will show all the addresses associated
with the slot, but this can be restricted using one of the sub options.
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
-cp cp_number
-sw sw_number
-slot n
-eth0 -eth1 -gate
If no operands are specified, the command displays all the IP addresses configured in the system.
For non-chassis-based switches, this command ignores all operands.
Examples To display the IP address for logical switch 0:
See Also ipAddrSet
286
For dual-CP systems, this specifies the CP card number to display (0 or 1).
For dual-domain systems, this specifies the switch number to display (0 or 1).
For chassis systems specify the slot for a blade
For a slot show only the selected ethernet interface or the gateway
switch:admin> ipaddrshow -sw 0
Ethernet IP Address: 192.168.166.147
Ethernet Subnetmask: 255.255.255.0
Fibre Channel IP Address: 0.0.0.0
Fibre Channel Subnetmask: 0.0.0.0
Fabric OS Command Reference
53-1000599-01