Portcfgdefault - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

2

portCfgDefault

portCfgDefault
Restores the port configuration to factory default values.
Synopsis portcfgdefault [slotnumber/][ge]portnumber
Description Use this command to reset any special configuration values on a port to their factory defaults. This
command will disable ports capable of routing persistently, which is the factory default value. You
can view the current port configuration using the portCfgShow command.
This command does not change the state of a port. To make an E_Port go back to the online state,
use either switchDisable/switchEnable or portDisable/portEnable.
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
slotnumber
portnumber
Examples To reset a port to factory defaults:
To reset a GbE port to factory defaults:
See Also portCfgEPort, portCfgGPort, portCfgLongDistance, portCfgLPort, portCfgPersistentDisable,
portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort
436
For bladed systems only, specify the slot number of the port to display,
followed by a slash (/).
Specify the number of the port to be returned to default values, relative to its
slot for bladed systems. Use switchShow to list valid ports.
switch:admin> portcfgdefault 1/3
switch:admin> portcfgdefault 8/ge1
Fabric OS Command Reference
53-1000599-01