Ficoncupset - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

ficonCupSet

Sets FICON-CUP parameters for a switch.
Synopsis ficoncupset fmsmode enable | disable
ficoncupset modereg bitname 0 | 1
Description Use this command to set FICON-CUP (Control Unit Port) parameters for a switch. All the parameters
described below can be set while the switch is online. Changes to parameters are effective
immediately. A reboot is not required for the changes to take effect.
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
fmsmode
modereg
Examples To enable FMS mode for the switch:
To set ASM bit in the mode register for the switch:
See Also ficonCupShow
Fabric OS Command Reference
53-1000599-01
Enable or disable the FICON Management Server (FMS) mode for the switch.
When the operand is fmsmode, the argument is either enable or disable.
If you use PID Format 2, you cannot enable fmsmode.
Set a bit in the FICON-CUP mode register. When the operand is modereg, one
of the following bitname operands should be specified, followed by 0 or 1:
POSC Programmed offline state control
UAM User alert mode
ASM Active=saved mode
DCAM Director clock alert mode
ACP Alternate control prohibited
HCP Host control prohibited
switch:admin> ficoncupset fmsmode enable
fmsmode for the switch is now Enabled
switch:admin> ficoncupset modereg ASM 1
Active=Saved Mode bit is set to 1
2
ficonCupSet
199