Errfilterset - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual

errFilterSet

Sets a filter for an error log destination.
Synopsis errfilterset [-d "destination"][-v "severity"]
Description Use this command to set a filter for an error log destination. A filter is set based on the severity level
of the messages.
If no parameters are specified, this command displays the filters that are currently in use.
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
-d "destination"
-v "severity"
Examples To display the current filter settings:
To set the filter severity level for the console:
See Also errDump, errShow
Fabric OS Command Reference
53-1000599-01
Specify the destination to set the filter. "console" is the only valid value at this
time.
Specify the minimum severity level of the message to pass through the filter.
Valid values are "INFO", "WARNING", "ERROR", or "CRITICAL".
switch:admin> errfilterset
console: filter severity = WARNING
switch:admin> errfilterset -d "console" -v "WARNING"
2
errFilterSet
125