Re-Mark Update User Priority Configuration; Acl Re-Mark Out-Of-Profile Configuration; Acl Group Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Re-Mark Update User Priority configuration

The following table describes the Update User Priority Configuration commands.
Table 161 ACL Update User Priority Configuration commands
Command
access-control list <1-762>
re-mark in-profile dot1p
<0-7>
[no] access-control list
<1-762> re-mark in-profile
use-tos-precedence
default access-control list
<1-762> re-mark
show access-control list
<1-762> re-mark

ACL Re-mark Out-of-Profile configuration

The following table describes the Re-mark Out-of-Profile Configuration commands.
Table 162 ACL Re-mark Out-of-Profile Configuration commands
Command
access-control list <1-762>
re-mark out-profile dscp
<0-63>
default access-control list
<1-762> re-mark
show access-control list
<1-762> re-mark

ACL Group configuration

These commands allow you to compile one or more ACLs into an ACL Group. Once you create an ACL Group, you
can assign the ACL Group to one or more ports.
The following table describes the ACL Group Configuration commands.
Table 163 ACL Group Configuration commands
Command
access-control group <1-762> list
<1-762>
no access-control group <1-762>
list <1-762>
show access-control group <1-762>
Description
Defines 802.1p value. The value is the priority bits information in the packet
structure.
Command mode: Global configuration
Enable or disable mapping of TOS (Type of Service) priority to 802.1p priority
for In-Profile packets. When enabled, the TOS value is used to set the 802.1p
value.
Command mode: Global configuration
Resets UP1P settings to their default values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC
Description
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected value.
The switch sets the DSCP value on Out-of-Profile packets.
Command mode: Global configuration
Resets the update DSCP parameters for Out-of-Profile packets to their default
values.
Command mode: Global configuration
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC
Description
Adds the selected ACL to the ACL Group.
Command mode: Global configuration
Removes the selected ACL from the ACL Group.
Command mode: Global configuration
Displays the current ACL group parameters.
Command mode: All except User EXEC
Configuration Commands 135