Igmpv3 Snooping Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

IGMP Snooping commands
Table 139
Command
[no] ip igmp snoop flood
[no] ip igmp snoop aggregate
ip igmp snoop source-ip <IP
address>
ip igmp snoop vlan <1-4094>
no ip igmp snoop vlan <1-4094>
no ip igmp snoop vlan all
[no] ip igmp snoop vlan <1-4094>
fastleave
ip igmp snoop enable
no ip igmp snoop enable
show ip igmp snoop

IGMPv3 Snooping configuration

The following table describes the IGMP version 3 Snooping Configuration commands.
IGMPv3 Snooping commands
Table 140
Command
ip igmp snoop igmpv3 sources
<1-64>
{ }
[no] ip igmp snoop igmpv3 v1v2
Description
Configures the switch to flood unregistered IP multicast reports to all
ports.
Command mode: Global configuration
Enables or disables IGMP Membership Report aggregation.
Command mode: Global configuration
Configures the source IP address used as a proxy for IGMP Group
Specific Queries.
Command mode: Global configuration
Adds the VLAN to IGMP Snooping.
Command mode: Global configuration
Removes the VLAN from IGMP Snooping.
Command mode: Global configuration
Removes all VLANs from IGMP Snooping.
Command mode: Global configuration
Enables or disables FastLeave processing. FastLeave allows the
switch to immediately remove a port from the IGMP port list, if the
host sends a Leave message, and the proper conditions are met. This
command is disabled by default.
Command mode: Global configuration
Enables IGMP Snooping.
Command mode: Global configuration
Disables IGMP Snooping.
Command mode: Global configuration
Displays the current IGMP Snooping parameters.
Command mode: All except User EXEC
Description
Configures the maximum number of IGMP multicast sources to snoop
from within the group record. Use this command to limit the number
of IGMP sources to provide more refined control.
Command mode: Global configuration
Enables or disables snooping on IGMP version 1 and version 2
reports. When disabled, the switch drops IGMPv1 and IGMPv2
reports. The default value is enabled.
Command mode: Global configuration
Configuration Commands
158