Igmpv3 Snooping Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

Table 143 IGMP Snoop Menu options
Command
srcip <IP address>
add <1-4094>
rem <1-4094>
clear
fastlv <1-4094>
disable|enable
ena
dis
cur

IGMPv3 Snooping configuration

Command: /cfg/l3/igmp/snoop/igmpv3
[IGMP V3 Snoop Menu]
The following table describes the IGMPv3 Snooping Configuration Menu options.
Table 144 IGMPv3 Snooping Menu options
Command
sources <1-64>
v1v2 enable|disable
exclude enable|disable
ena
dis
cur
Description
Configures the source IP address used as a proxy for IGMP Group Specific
Queries.
Adds the VLAN to IGMP Snooping.
Removes the VLAN from IGMP Snooping.
Removes all VLANs from IGMP Snooping.
Enables or disables FastLeave processing. FastLeave allows the switch to
immediately remove a port from the IGMP port list, if the host sends a Leave
message, and the proper conditions are met. This command is disabled by default.
Enables IGMP Snooping.
Disables IGMP Snooping.
Displays the current IGMP Snooping parameters.
sources - Set the number of sources to snoop in group record
v1v2 - Enable/disable snooping IGMPv1/v2 reports
exclude - Enable/disable snooping EXCLUDE mode reports
ena - Enable IGMPv3 Snooping
dis - Disable IGMPv3 Snooping
cur - Display current IGMP Snooping V3 configuration
Description
Configures the maximum number of IGMP multicast sources to snoop
from within the group record. Use this command to limit the number of
IGMP sources to provide more refined control.
Enables or disables snooping on IGMP version 1 and version 2 reports.
When disabled, the switch drops IGMPv1 and IGMPv2 reports. The
default value is enabled.
Enables or disables snooping on IGMPv3 Exclude Reports. When
disabled, the switch ignores Exclude Reports. The default value is
enabled.
Enables IGMP version 3. The default value is disabled.
Disables IGMP version 3.
Displays the current IGMP version 3 parameters.
Configuration Menu
175