Routing Information Protocol Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Command Reference Manual

The rmap number (1-32) and the path number (1-8) represent the AS path you wish to configure. The following table
describes the Autonomous System Path Configuration Menu options.
Table 130 Autonomous System Path Configuration Menu options
Command
as <1-65535>
action permit|deny
enable
disable
delete
cur

Routing Information Protocol configuration

Command: /cfg/l3/rip
[Routing Information Protocol Menu]
if
update
redist
on
off
current
NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by default.
The following table describes the RIP Configuration Menu options.
Table 131 RIP Configuration Menu options
Command
if <1-256>
update <1-120>
redist
on
off
cur
Description
Sets the Autonomous System filter's path number.
Permits or denies Autonomous System filter action.
Enables the Autonomous System filter.
Disables the Autonomous System filter.
Deletes the Autonomous System filter.
Displays the current Autonomous System filter configuration.
- RIP Interface Menu
- Set update period in seconds
- RIP Route Redistribute Menu
- Globally turn RIP ON
- Globally turn RIP OFF
- Display current RIP configuration
Description
Displays the RIP Interface menu.
Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Displays the RIP Route Redistribute menu.
Globally turns RIP on.
Globally turns RIP off.
Displays the current RIP configuration.
Configuration Menu 128