Table of Contents
Advertisement
Table 100
Port Configuration Menu options
Command
mrate <0-262143>|dis
drate <0-262143>|dis
ena
dis
cur
Temporarily disabling a port
To temporarily disable a port without changing its stored configuration attributes, enter the following
command at any prompt:
Main# /oper/port <port number>/dis
Because this configuration sets a temporary state for the port, you do not need to use apply or
save. The port state will revert to its original configuration when the switch is reset. See the "Menu
information" section in the "Operations Menu" chapter for other operations-level commands.
Port link configuration
Command: /cfg/port <port number>/gig
[Gigabit Link Menu]
Use these menu options to set port parameters for the port link.
Link menu options are described in the following table and display on the Gigabit port configuration
menus for the switch. Using these configuration menus, you can set port parameters such as speed,
duplex, flow control, and negotiation mode for the port link.
Description
Limits the number of multicast packets per second to the specified value. If
disabled (dis), the port forwards all multicast packets.
Limits the number of unknown unicast packets per second to the specified value.
If disabled (dis), the port forwards all unknown unicast packets.
Enables the port.
Disables the port. To temporarily disable a port without changing its
configuration attributes, see the "Temporarily disabling a port" section later in
this chapter.
Displays current port parameters.
speed
- Set link speed
mode
- Set full or half duplex mode
fctl
- Set flow control
auto
- Set auto negotiation
cur
- Display current gig link configuration
Configuration Menu 132
Advertisement
Table of Contents
