Ntp Server Configuration; System Snmp Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

NTP server configuration

Command: /cfg/sys/ntp
[NTP Server Menu]
This menu enables you to synchronize the switch clock to a Network Time Protocol (NTP) server. By
default, this option is disabled.
The following table describes the NTP Server Configuration Menu options.
NTP Server Configuration Menu options
Table 83
Command
prisrv <IP address>
secsrv <IP address>
intrval <1-44640>
on
off
cur

System SNMP configuration

Command: /cfg/sys/ssnmp
[SNMP Menu]
prisrv - Set primary NTP server address
secsrv - Set secondary NTP server address
intrval - Set NTP server resync interval
on - Turn NTP service ON
off - Turn NTP service OFF
cur - Display current NTP configuration
Description
Configures the IP addresses of the primary NTP server to which you want to
synchronize the switch clock.
Configures the IP addresses of the secondary NTP server to which you want to
synchronize the switch clock.
Specifies the interval, that is, how often, in minutes (1-44640), to resynchronize the
switch clock with the NTP server. The default is 1440 seconds.
Enables the NTP synchronization service.
Disables the NTP synchronization service. This is the default.
Displays the current NTP service settings.
snmpv3 - SNMPv3 Menu
name - Set SNMP "sysName"
locn - Set SNMP "sysLocation"
cont - Set SNMP "sysContact"
rcomm - Set SNMP read community string
wcomm - Set SNMP write community string
timeout - Set timeout for the SNMP state machine
auth - Enable/disable SNMP "sysAuthenTrap"
linkt - Enable/disable SNMP link up/down trap
ufd - Enable/disable SNMP Uplink Failure Detection trap
cur - Display current SNMP configuration
Configuration Menu
113