Ntp Server Configuration - HP ProLiant BL p-Class GbE2 Command Reference Manual

The Configuration Menu

NTP Server Configuration

Command: /cfg/sys/ntp
[NTP Server Menu]
This menu enables you to synchronize the GbE2 Interconnect Switch clock to a Network
Time Protocol (NTP) server. By default, this option is disabled.
The following table describes the NTP Server Configuration Menu options.
Table 6-6: NTP Server Configuration Menu Options
Command
server <NTP Server IP address>
intrval <resync interval in
minutes>
tzone <timezone offset, in HH:MM
format>
dlight disable|enable
on
off
cur
6-10
HP CONFIDENTIAL Codename: Strawberry Part Number: 331404-001 Last Saved On: 7/17/03 12:57 PM
server - Set NTP server address
intrval - Set NTP server resync interval
tzone - Set NTP timezone offset from GMT
dlight - Enable or disable NTP daylight saving time
on - Turn NTP service ON
off - Turn NTP service OFF
cur - Display current NTP configuration
HP ProLiant BL p-Class GbE2 Interconnect Switch Command Reference Guide
Description
Prompts for the IP addresses of the NTP server
to which you want to synchronize the GbE2
Interconnect Switch clock.
Specifies the interval, that is, how often, in
minutes (1-2880), to resynchronize the GbE2
Interconnect Switch clock with the NTP server.
Prompts for the NTP time zone offset from
Greenwich Mean Time (GMT), in hours and
minutes.
Disables or enables daylight saving time in the
system clock. When enabled, the GbE2
Interconnect Switch will add an extra hour to the
system clock so that it is consistent with the
local clock. By default, this option is disabled.
Enables the NTP synchronization service.
Disables the NTP synchronization service. This
is the default.
Displays the current NTP service settings.