Ntp Server Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Command Reference Manual

If secure backdoor is enabled (secbd ena), type in notacacs as a backdoor to bypass
TACACS+ checking, and use the administrator password to log into the switch. The switch allows
this only if TACACS+ servers are not available.

NTP server configuration

Command: /cfg/sys/ntp
[NTP Server Menu]
This menu enables you to synchronize the switch clock to a Network Time Protocol (NTP) server. By
default, this option is disabled.
The following table describes the NTP Server Configuration Menu options.
NTP Server Configuration Menu options
Table 83
Command
prisrv <IP address>
mgt|data
secsrv <IP address>
mgt|data
intrval <1-44640>
on
off
cur
prisrv - Set primary NTP server address
secsrv - Set secondary NTP server address
intrval - Set NTP server resync interval
on - Turn NTP service ON
off - Turn NTP service OFF
cur - Display current NTP configuration
Description
Configures the IP addresses of the primary NTP server to which you want to
synchronize the switch clock.
By default, the mgt option for the management port is used. To use data ports,
specify the data option.
Configures the IP addresses of the secondary NTP server to which you want to
synchronize the switch clock.
Specifies the interval, that is, how often, in minutes (1-44640), to resynchronize the
switch clock with the NTP server. The default is 1440 seconds.
Enables the NTP synchronization service.
Disables the NTP synchronization service. This is the default.
Displays the current NTP service settings.
Configuration Menu
120