This Paper Cannot Be Used; Cannot Print As Selected. Another Roll Is In Use - Canon imagePROGRAF iPF820 User Manual

Insufcient paper for job
The printer has received a print job longer than the
amount of roll paper left when ManageRemainRoll
in the printer menu is On and one of the following
settings is selected.
•
An option other than Roll Paper (Auto) is selected
in Paper Source in the printer driver.
•
During HP-GL/2 printing, GL2 Settings > Paper
Source in the printer menu is set to an option
other than Automatic.

This paper cannot be used.

Paper that is too large for the printer has been loaded. Lift the Release Lever and load paper of the correct
Paper that is too small for the printer has been
loaded.
Paper has been loaded that is too small to print
the test pattern for printhead adjustment or nozzle
checking.

Cannot print as selected. Another roll is in use.

A printed document remains in the Output Tray
without being cut and a print job was received that
species the other roll.
Cause
Cause
Cause
Corrective Action
Press the Online button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of the
document.
Hold down the Stop button for a second or more to
cancel printing.
Either change the printer driver Paper Source setting
or the GL2 Settings > Paper Source setting in the
printer menu or replace the roll with a roll that has
enough paper for the print job, and then try printing
again.
(→P.125)
(→P.118)
Corrective Action
size.
(→P.109)
Lift the Release Lever and load paper of the correct
size.
(→P.109)
Lift the Release Lever and load unused paper A4
or larger. More than one sheet may be required
depending on the adjustment.
Corrective Action
Follow these steps to load the other roll after cutting
the printed document.
1.
Hold down the Stop button for a second or more
to cancel printing.
2.
Cut the printed document.
(→P.139)
3.
Load the other roll and resend the print job.
(→P.89)
Messages regarding paper
Error Message 653